Related QuestionsĬan a 3D printer be used to print remote-controlled aircraft? You can find everything about PLA Moose here. The alignment of the 3D printed rc plane is not optimized. It will need 5x 9gm servos, although I am yet to draw the mount for the rudder servo. The wing has a 16mm carbon spar and a 3mm carbon strut in the tailplane.
A good CA glue and a 400 grit sandpaper can be useful when it comes to assembling. Assembling the individual parts should be almost child’s play for any interested modeler. The prototype of the PLA Moose was – as the name suggests – printed in PLA, which is also recommended. It is not difficult to print and therefore a good model to start with rc planes. But it doesn’t matter, because the aerobatic plane with a wingspan of one meter is a solid model. Looking at it, you can’t really understand why you’re dealing with a moose.
Moose – an unusual name for an RC aircraft. The PLA Moose by MicroSport via thingiverse Nevertheless, this is a popular and attractive model – especially for advanced users of remote-controlled aircraft.Īre you interested in a Red Duck? On Thingiverse you can find the model. You’ll need to set aside a lot of time, though, as the printing time for the individual parts is around 110 hours.
However, it is also possible through other 3D printers to assemble individual parts into a great overall image. The Red Duck is printed by Christou from the Wersybot – a derivative of the Printrbot. There are quite a few videos on the internet showing the model performing spectacular aerobatic maneuvers. If you have a lot of flying experience with RC planes, then you could even fly the Red Duck in acrobatics shows. The center of gravity is far forward and the nose is added later. The red duck has a wingspan of 1.35 meters to offer and actually looks a bit like its namesake. A related model is the Red Duck, which was also developed by Christou.
0 kommentar(er)
